D-Link DGS-510 Reference Manual page 282

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Switch# configure terminal
Switch(config)# interface eth1/0/1
Switch(config-if)# gvrp timer leave-all 500
Switch(config-if)#
31-8 show gvrp configuration
This command is used to display the GVRP settings.
show gvrp configuration [interface [INTERFACE-ID [,|-]]]
Parameters
configuration
interface
INTERFACE-ID [,|-]
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command only displays GVRP related configurations.
Example
This example shows how to display the GVRP configuration for the global configuration.
Switch# show gvrp configuration
Global GVRP State
Dynamic VLAN Creation : Disabled
Switch#
This example shows how to display the GVRP configuration on interfaces eh3/0/5 to eth3/06.
Specifies to display the GVRP configuration. If the interface is not
specified, the GVRP global configuration is displayed.
Specifies to display the GVRP interface configuration. If the
interface ID is not specified, all interfaces are displayed.
(Optional) Specifies the interfaces used to display the configuration.
Specify a single interface or a range of interfaces, separated by a
hyphen, or a series of interfaces separated by comma.
: Enabled
279