Table of Contents
Advertisement
DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
This feature is used to block IPC traffic or not. If the IPC state on the port is disabled, the traffic from
the IPC will be blocked.
Example
This example shows how to enable the state of IPC with the IP address 172.18.60.1.
Switch# configure terminal
Switch(config)# surveillance vlan onvif-ipc 172.18.60.1 state enable
Switch(config)#
68-7
surveillance vlan onvif-ipc description
This command is used to configure the description of the ONVIF recognized IPC. Use the no
command to remove the description.
surveillance vlan onvif-ipc IP-ADDRESS [mac-address MAC-ADDRESS] description TEXT
no surveillance vlan onvif-ipc IP-ADDRESS [mac-address MAC-ADDRESS] description
Parameters
IP-ADDRESS
MAC-ADDRESS
TEXT
Default
By default, there is no description defined for an ONVIF recognized IPC.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to configure the description of the ONVIF recognized IPC with only the IP
address of the IPC, or both the IP and MAC address of the IPC. If there is more than one IPC with the
same IP address and the MAC addresses of those IPCs are not specified, the description of those
IPCs will be configured.
Example
This example shows how to define the description of the IPC with an IP address of 172.18.60.1 to
'ipc1'.
Switch# configure terminal
Switch(config)# surveillance vlan onvif-ipc 172.18.60.1 description ipc1
Switch(config)#
68-8
surveillance vlan onvif-nvr description
This command is used to configure the description of an ONVIF recognized NVR. Use the no
command to remove this description.
Enter the IP address of the ONVIF recognized IPC here.
(Optional) Enter the MAC address of the IPC that is recognized with
ONVIF.
Enter the description of the ONVIF recognized IPC here. This can
be up to 32 characters long.
628
Advertisement
Table of Contents
