D-Link DGS-510 Reference Manual page 650

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Command Default Level
Level: 12.
Usage Guideline
This command is used to specify the interface IP address to be used as the source address for
initiating TFTP packets. To use this command together with the out of band management port, specify
the interface ID for the out of band management port.
Example
This example shows how to download software using interface IP of VLAN 100.
Switch# configure terminal
Switch(config)# ip tftp source-interface vlan100
Switch(config)#
70-8 show boot
This command is used to display the boot configuration file and the boot image setting.
show boot [unit UNIT-ID]
Parameters
UNIT-ID
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command is used to display the boot configuration file and the boot image setting.
Example
This example shows how to display system boot information.
Switch#show boot
Unit 1
Boot image: /c:/FW-1.40.003.had
Boot config: /c:/config.cfg
Switch#
70-9 show running-config
This command is used to display the commands in the running configuration file.
show running-config [effective | all] [interface INTERFACE-ID]
(Optional) Specifies the unit to be displayed.
647