D-Link DGS-510 Reference Manual page 673

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to enable ingress checking for packets received by the interface. If ingress
checking is enabled, the packet will be dropped if the received port is not a member port of the VLAN
classified for the received packet.
Example
This example shows how to set ingress checking to enabled port eth1/0/1.
Switch# configure terminal
Switch(config)# interface eth1/0/1
Switch(config-if)# ingress-checking
Switch(config-if)#
75-3 show vlan
This command is used to display the parameters for all configured VLANs or one VLAN on the Switch.
show vlan [VLAN-ID [, | -] | interface [INTERFACE-ID [, | -]] | mac-vlan]
Parameters
VLAN-ID
interface INTERFACE-ID
,
-
mac-vlan
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command is used to display the parameters for all configured VLANs or one VLAN on the Switch.
Example
This example shows how to display all the current VLAN entries.
(Optional) Specifies a list of VLANs to display the member port
information. If the VLAN is not specified, all VLANs are displayed.
The valid range is from 1 to 4094.
(Optional) Specifies the port to display the VLAN related setting.
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space before and after the
comma.
(Optional) Specifies a range of interfaces. No space before and
after the hyphen.
(Optional) Specifies to display mac-based VLAN information.
670