Table of Contents
Advertisement
DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Switch# copy tftp: //10.1.1.254/image.had flash: image.had
Address of remote host [10.1.1.254]?
Source filename [image.had]?
Destination filename [image.had]?
Accessing tftp://10.1.1.254/image.had...
Transmission start...
Transmission finished, file length 8315060 bytes.
Transmission to slave start.................
Transmission to slave finished, file length 8315060 bytes.
Please wait, programming flash.............. Done.
Wait slave programming flash complete...
Done.
Switch#
This example shows the error message that will be displayed when there is not enough space on the
flash.
Switch# copy tftp: //10.1.1.254/image.had flash: image.had
Address of remote host [10.1.1.254]?
Source filename [image.had]?
Destination filename [image.had]?
Accessing tftp://10.1.1.254/image.had...
Transmission start...
Transmission finished, file length 8315060 bytes.
Transmission to slave start................. Done.
Transmission to slave finished, file length 8315060 bytes.
Please wait, programming flash.............. %0.
ERROR: Uint2: Not enough space.
Done.
Switch#
70-7
ip tftp source-interface
This command is used to specify the interface IP address to be used as the source address for
initiating TFTP packets. Use the no form of this command to revert to the default setting.
ip tftp source-interface INTERFACE-ID
no ip tftp source-interface
Parameters
INTERFACE-ID
Default
The IP address of the closest interface will be used.
Command Mode
Global Configuration Mode.
Specifies the interface ID. The interface IP address will be used as
the source address for initiating TFTP packets.
646
Done.
Advertisement
Table of Contents
