Table of Contents
Advertisement
DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Default
By default, this value is 24.
Command Mode
Use the EXEC Mode or Privilege EXEC Mode for the terminal length command.
Use the Global Configuration Mode for the terminal length default command.
Command Default Level
Level: 1 (for the terminal length command).
Level: 12 (for the terminal length default command).
Usage Guideline
When the terminal length is 0, the display will not stop until it reaches the end of the display.
If the terminal length is specified to a value other than 0, for example 50, then the display will stop
after every 50 lines. The terminal length is used to set the number of lines displayed on the current
terminal screen. This command also applies to Telnet and SSH sessions. Valid entries are from 0 to
512. The default is 24 lines. A selection of 0's instructs the Switch to scroll continuously (no pausing).
Output from a single command that overflows a single display screen is followed by the --More--
prompt. At the --More-- prompt, press CTRL+C, q, Q, or ESC to interrupt the output and return to the
prompt. Press the Spacebar to display an additional screen of output, or press Return to display one
more line of output. Setting the screen length to 0 turns off the scrolling feature and causes the entire
output to display at once. Unless the default keyword is used, a change to the terminal length value
applies only to the current session. When using the no form of this command, the number of lines in
the terminal display screen is reset to 24.
The terminal length default command is available in the global configuration mode. The command
setting does not affect the current existing terminal sessions but affects the new terminal sessions that
are activated later. Only the default terminal length value can be saved.
Example
This example shows how to change the lines to be displayed on a screen to 60.
Switch# terminal length 60
Switch#
5-20
terminal speed
This command is used to setup the terminal speed. Use the no form of this command to revert to the
default setting.
terminal speed BPS
no terminal speed
Parameters
BPS
Default
By default, this value is 115200.
Command Mode
Global Configuration Mode.
display will not stop until it reaches the end of the display.
Specifies the console rate in bits per second (bps).
78
Advertisement
Table of Contents
