D-Link DGS-510 Reference Manual page 64

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Switch# show access-list ip simple-ip-acl
IP access list simple-ip-acl(ID:3994)
10 permit tcp any 10.20.0.0 0.0.255.255
20 permit tcp any host 10.100.1.2
30 permit icmp any any
Counter enable on following port(s):
Ingress port(s): eth1/0/5-eth1/0/8
Switch#
4-23 show vlan access-map
This command is used to display the VLAN access-map configuration information.
show vlan access-map [MAP-NAME]
Parameters
MAP-NAME
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
If no access-map name is specified, all VLAN access-map information will be displayed. If the user
enables the ACL hardware counter for an access-map, the counter will be displayed based on each
sub-map.
Example
This example shows how to display the VLAN access-map.
Switch# show vlan access-map
VLAN access-map vlan-map 10
match ip access list: stp_ip1(ID: 1888)
action: forward
VLAN access-map vlan-map 20
match mac access list:
action: redirect
Switch#
This example shows how to display the contents of the VLAN access-map if its hardware counter is
enabled.
(Ing: 6532 packets)
(Ing: 8758 packets)
(Optional) Specifies the name of the VLAN access map being
configured. The name can be up to 32 characters.
ext_mac(ID: 6995)
eth1/0/5
61
(Ing: 12410 packets)