D-Link DGS-510 Reference Manual page 476

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Switch# configure terminal
Switch(config)# interface eth3/0/1
Switch(config-if)# poe power-inline never
Switch(config-if)#
This example shows how to combine a time-range profile called "day-time" with the PoE port, eth3/0/1.
Switch# configure terminal
Switch(config)# interface eth3/0/1
Switch(config-if)# poe power-inline auto time-range day-time
Switch(config-if)#
53-6 poe usage-threshold
This command is used to configure the utilization threshold to record a log. Use the no form of this
command to restore to the default setting.
poe unit UNIT-ID usage-threshold PERCENTAGE
no poe unit UNIT-ID usage-threshold
Parameters
UNIT-ID
PERCENTAGE
Default
By default, this value is 99.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
When the usage threshold is configured, if the utilization of the PSE exceeds the configured threshold,
then the EXCEED log will be recorded. Once the percentage decreases and become lower than the
threshold, then the RECOVER log is recorded.
Example
This example shows how to configure the usage threshold to 50%.
Switch# configure terminal
Switch(config)# poe unit 1 usage-threshold 50
Switch(config)#
53-7 snmp-server enable traps poe
This command is used to enable the sending of PoE notifications. Use the no form of this command
to disable sending power over Ethernet notifications.
snmp-server enable traps poe [unit UNIT-ID]
Specifies the stacking unit's ID to be configured. This parameter is
only available, if stacking is enabled.
Specifies the usage threshold to generate a log. The valid range is
from 1 to 99. The unit is percentage.
473