Table of Contents
Advertisement
DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Parameters
SOURCE-URL
LOCATION
Default
None.
Command Mode
Privileged EXEC Mode.
Command Default Level
Level: 15.
Usage Guideline
None.
Example
This example shows how to copy debug buffer information to a TFTP server (10.90.90.99).
Switch# debug copy buffer tftp: //10.90.90.99/abc.txt
Address of remote host [10.90.90.99]?
Destination filename [abc.txt]?
Accessing tftp://10.90.90.99/abc.txt...
Transmission starts...
Finished network upload(65739) bytes.
Switch#
14-5
debug clear buffer
This command is used to clear the debug buffer.
debug clear buffer
Parameters
None.
Default
None.
Command Mode
Privileged EXEC Mode.
Command Default Level
Level: 15.
Usage Guideline
Use this command to clear the debug buffer information.
Specifies the source URL for the source file to be copied. It must be
one of the following keywords.
buffer: Specifies to copy the debug buffer information.
error-log: Specifies to copy the error log information.
tech-support: Specifies to copy the technical support information.
Specifies the IPv4 or IPv6 address of the TFTP server.
140
Advertisement
Table of Contents
