D-Link DGS-510 Reference Manual page 427

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
no name NAME
Parameters
NAME
Default
The default name is the Switch's MAC address.
Command Mode
MST Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Two or more switches with the same VLAN mapping and configuration version number are
considered to be in different MST regions if the region names are different.
Example
This example shows how to configure the MSTP configuration name to "MName".
Switch# configure terminal
Switch(config)# spanning-tree mst configuration
Switch(config-mst)# name MName
Switch(config-mst)#
48-3 revision
This command is used to configure the revision number for the MST configuration. Use the no form of
this command to revert to the default setting.
revision VERSION
no revision
Parameters
VERSION
Default
By default, this value is 0.
Command Mode
MST Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Two Ethernet switches that have the same configuration but different revision numbers are
considered to be part of two different regions.
Specifies the name given for a specified MST region. The name
string has a maximum length of 32 characters and the type is a
general string which allows spaces.
Specifies the revision number for the MST configuration. The range
is from 0 to 65535.
424