D-Link DGS-510 Reference Manual page 418

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Switch# configure terminal
Switch(config)# vlan 1000
Switch(config-vlan)# ipv6 mld snooping query-version 1
Switch(config-vlan)#
47-11 ipv6 mld snooping report-suppression
This command is used to enable MLD report suppression on a VLAN. Use the no form of this
command to disable report suppression on a VLAN.
ipv6 mld snooping report-suppression
no ipv6 mld snooping report-suppression
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The command is only available for VLAN interface configuration. The report suppression function only
works for MLDv1 traffic.
When report suppression is enabled, the Switch suppresses the duplicate reports sent by hosts. The
suppression for the same group report or leave will continue until the suppression time expired. For
report or leave messages to the same group, only one report or leave message is forwarded. The
remaining report and leave messages are suppressed.
Example
This example shows how to enable MLD report suppression.
Switch# configure terminal
Switch(config)# vlan 100
Switch(config-vlan)# ipv6 mld snooping report-suppression
Switch(config-vlan)#
47-12 ipv6 mld snooping robustness-variable
This command is used to set the robustness variable used in MLD snooping. Use the no form of this
command to revert to the default value.
ipv6 mld snooping robustness-variable VALUE
no ipv6 mld snooping robustness-variable
Parameters
VALUE Specifies the robustness variable. The range is from 1 to 7.
415