Digital Diagnostics Monitoring (Ddm) Commands - D-Link DGS-510 Reference Manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
22. Digital Diagnostics Monitoring (DDM)
Commands
22-1 show interfaces transceiver
This command is used to display the current SFP module operating parameters.
show interfaces [INTERFACE-ID [,|-] transceiver [detail]
Parameters
INTERFACE-ID [,|-]
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the current SFP module operating transceiver monitoring parameters
values for specified ports.
Example
This example shows how to display current operating parameters for all ports valid for transceiver
monitoring.
Switch#show interfaces transceiver
++ : high alarm, +
mA: milliamperes, mW: milliwatts
Transceiver Monitoring traps: None
Port
------- ------------ ------------ ------------ ------------ ------------
eth2/0/23
eth3/0/25
eth3/0/26
Total Entries: 3
Switch#
This example shows how to display detailed transceiver monitoring information for all ports which are
valid for transceiver monitoring.
(Optional) Specifies multiple interfaces for transceiver monitoring
status display. If no interface ID is specified, transceiver monitoring
statuses on all valid interfaces are displayed.
: high warning, -
Temperature Voltage
(Celsius) (V)
30.090 3.353
29.316 3.302
31.617 3.297
: low warning, -- : low alarm
Bias Current TX Power
(mA) (mW)
16.794(++) 0.258
5.326 0.529
5.170 0.527
205
RX Power
(mW)
0.000(--)
0.506
0.504