Digital Diagnostic Monitoring (Ddm) Commands - D-Link xStack DGS-3400 Series Cli Reference Manual

xStack
This DDM UI specification describes the Digital Diagnostic Monitoring functionality and specifications based on SFF-8472
standard. Functions of this software module apply on L2 and L3 Ethernet switches, which contain SFP interface.
The Digital Diagnostic Monitoring (DDM) commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command
config ddm ports
config ddm ports
config ddm ports
config ddm ports
config ddm ports
config ddm ports
config ddm log
config ddm trap
show ddm ports
show ddm ports
show ddm
Each command is listed, in detail, in the following sections.
config ddm ports temperature_threshold
Purpose
Syntax
Description
Parameters
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch CLI Manual
D D
IGITAL IAGNOSTIC
Parameters
[<portlist> | all] temperature_threshold { high_alarm < float > | low_alarm < float
> | high_warning < float > | low_warning < float >} (1)
[<portlist> | all] voltage_threshold { high_alarm < float > | low_alarm < float > |
high_warning < float > | low_warning < float >} (1)
[<portlist> | all] bias_current_threshold { high_alarm < float > | low_alarm < float
> | high_warning < float > | low_warning < float >} (1)
[<portlist> | all] tx_power_threshold { high_alarm < float > | low_alarm < float > |
high_warning < float > | low_warning < float >} (1)
[<portlist> | all] rx_power_threshold { high_alarm < float > | low_alarm < float > |
high_warning < float > | low_warning < float >} (1)
[<portlist> | all] { state [enable | disable] | shutdown [alarm | warning| none]} (1)
[enable | disable]
[enable | disable]
{<portlist>} status
{<portlist>} configuration
To configure the thresholds of temperature of the specified ports.
config ddm ports [<portlist> | all] temperature_threshold { high_alarm < float > |
low_alarm < float > | high_warning < float > | low_warning < float >} (1)
The command configures the temperature thresholds of the specified ports.
portlist - Specified a range of ports to be configured. (UnitID: port number).
all - If 'all' parameter is chosen, all SFP ports' operating parameters will be configured.
temperature_threshold - Specifies the threshold of SFP module's temperature.
high_alarm - High threshold for alarm. When the operating parameter rises above this value,
action associated with alarm is taken. The range of this parameter is -128 to 127.996 Celsius
degrees.
low_alarm - Low threshold for alarm. When the operating parameter falls below this value,
action associated with alarm is taken. The range of this parameter is -128 to 127.996 Celsius
degrees.
high_warning - High threshold for warning. When the operating parameter rises above this
value, action associated with warning is taken. The range of this parameter is -128 to
127.996 Celsius degrees.
low_warning - Low threshold for warning. When the operating parameter falls below this
value, action associated with warning is taken. The range of this parameter is -128 to
M
ONITORING
170
24
(DDM) C
OMMANDS