Chapter 27 Digital Diagnostic Monitoring (Ddm) Command List (Ei Mode Only) - D-Link DGS-3120-24PC Manual

®
xStack DGS-3120 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
Chapter 27 Digital Diagnostic
config ddm [trap | log] [enable | disable]
config ddm ports [<portlist> | all] [[temperature_threshold {high_alarm <degrees> | low_alarm
<degrees> | high_warning <degrees> | low_warning <degrees>} | voltage_threshold
{high_alarm <voltage> | low_alarm <voltage> | high_warning <voltage> | low_warning
<voltage>} | bias_current_threshold {high_alarm <milliampere> | low_alarm <milliampere> |
high_warning <milliampere> | low_warning <milliampere>} | tx_power_threshold {high_alarm
<milliwatts> | low_alarm <milliwatts> | high_warning <milliwatts> | low_warning <milliwatts>} |
rx_power_threshold {high_alarm <milliwatts> | low_alarm <milliwatts> | high_warning
<milliwatts> | low_warning <milliwatts>}] | {state [enable | disable] | shutdown [alarm | warning
| none]}]
show ddm
show ddm ports {<portlist>} [status | configuration]
27-1 config ddm
Description
The command configures the DDM log and trap action when encountering an exceeding alarm or
warning thresholds event.
Format
config ddm [trap | log] [enable | disable]
Parameters
trap - Specify whether to send traps, when the operating parameter exceeds the corresponding
threshold. The DDM trap is disabled by default.
log - Specify whether to send a log, when the operating parameter exceeds the corresponding
threshold. The DDM log is enabled by default.
enable - Specify to enable the log or trap sending option.
disable - Specify to disable the log or trap sending option.
Restrictions
Only Administrator, and Operator level users can issue this command.
Example
To configure DDM log state to enable:
Monitoring (DDM) Command
List (EI Mode Only)
270