BRS Link Configuration
BRS Link Configuration
The BRS link is reconfigured during the Link Installation or the Link Configuration wizards, or
from the Air Interface screen.
Both sites in a BRS Link must be configured identically.
Any changes to the frequency settings cause the link to re-
synchronize. A short loss of service will occur during re-
Note
synchronization.
To Configure BRS Channel Settings:
1. Set the Band Plan.
2. Select the Bandwidth required,
•
Single Band
•
Double Band
•
Quad Band
3. Select the Frequency from the pull-down menu.
4. Click Next. The system is re-synchronized to the changes.
Figure 25-4: BRS Channel Settings Post-Transition
WinLink 1000 User Manual
Release 1.9.40
Chapter 25
25-3