Rfp: General Radio Frame Pattern; Figure 10-10 Radio Frame; Table 10-2 Radio Frame; Table 10-3 Radio Frame - Radwin WinLink 1000 User Manual

RFP: General Radio Frame Pattern

Figure 10-10: Radio Frame Pattern
Five RFP types (A to E) are available. Under HSS the RFP must be configured by the user
depending on the type of the radio products, services and channel bandwidth in accordance
with the Table 10-2
The tables describe the efficiency of the air interface according to the RFP type, radio prod-
ucts mix, services and channel bandwidth. The tables may also be viewed in the RADWIN
Manager and in the Link Budget Calculator for both WinLink 1000 and RADWIN 2000. The
efficiency of the air interface will vary according to the product used
Table 10-2: Radio Frame Pattern Table - RADWIN 2000
RFP
40 MHz
TDM Ethernet
B Available Available
E Best fit Best fit
Table 10-3: Radio Frame Pattern Table - WinLink 1000
RPF
TDM
A Best fit
B N/A
C N/A
D N/A
E Available
Legend:
Best fit - optimal RFP choice for TDM and Ethernet services.
Available - available RFP for TDM and Ethernet services, but not optimal.
N/A - service unavailable
Select the RFP that gives you the Best Fit or Available for required system services and
select the channel bandwidth accordingly.
The RFP must be the same for each link within the collocated system.
Note
RFP: General Radio Frame Pattern
When setting the RPF, the following considerations should be borne in mind:
• When synchronizing RADWIN 2000 units you must use RFP B or E
WinLink 1000 User Manual
and Table 10-3.
20 MHz
TDM Ethernet
Available Available
Best fit Best fit
20 MHz
Ethernet TDM
Best fit Available
N/A Best fit
N/A N/A
N/A N/A
Available Available
Release 1.9.40
10 MHz
TDM Ethernet
Available Available
Best fit Best fit
10 MHz
Ethernet TDM
Available N/A
Available Best fit
Best fit N/A
N/A N/A
Available N/A
Chapter 10
.
5 MHz
TDM Ethernet
Best fit Best fit
Available Available
5 MHz
Ethernet
N/A
Available
Available
Best fit
N/A
10-8