Overview
This chapter describes the link configuration procedure, which is performed after the installa-
tion of both sides of the WinLink 1000 link, as set out in
Link configuration uses a Link Configuration wizard to redefine the configuration parameters
and fine-tune an operational link. Both sides of the link are configured simultaneously.
Link configuration allows you to configure link parameters, which do not lead to sync loss or
require a reset. Some may change service performance, in respect of which, warnings are dis-
played.
For ease of use, the Link Configuration wizard follows the same pattern as Link Installation.
You should therefore be familiar with the content of
The following parameters are configured using the Link Configuration Wizard:
•
System parameters
•
Channel settings
•
Transmission power and antenna settings
•
Service parameters
For new style IDU-E users: The procedure shown here is the same as for
IDU-C based links. The main window will show two trunk ports instead of
four.
Note
The Configuration Wizard has seven steps as shown in
WinLink 1000 User Manual
Configuring the Link
Release 1.9.40
Chapter
5.
Chapter
5.
Table 7-1
below.
Chapter 7
7-1