Community String; Private Mib Structure - Radwin WinLink 1000 User Manual

Community String

on each of the IDUs and ODUs in the link. Both agents communicate with each other over the
air using a proprietary protocol.
Each ODU has a single MAC address and a single IP address.
Note
To control and configure the device using the MIB, you should adhere to the following rules:
• The connection for control and configuration is to the local site, over any SNMP/UDP/
IP network.
• All Parameters should be consistent between both of the ODUs. Note that inconsis-
tency of air parameters can break the air connection. To correct air parameters incon-
sistency you must reconfigure each of the ODUs.
• Common practice is to configure the remote site first and then to configure the local
site.
• For some of the configuration parameters additional action must be taken before the
new value is loaded. Please refer to the operation in the parameters description.
• Some of the MIB parameters values are product dependent. It is strongly recommend
using the RADWIN Manager Application for changing these values. Setting wrong val-
ues may cause indeterminate results.
Community String
To control a link, all SNMP requests should go to the local site IP address.
See Table 4-4 for default Community strings.

Private MIB Structure

The sections in the private RADWIN MIB and its location in the MIB tree are shown in
Figure D-1 below:
WinLink 1000 User Manual Release 1.9.40
Appendix D
D-2