Default Winlink 1000 Settings; Table 4-4 Defaults - Radwin WinLink 1000 User Manual

Default WinLink 1000 Settings

The Link Installation and Configuration phases are both carried out with Wizards, which
"walk you through" the processes. The Wizards are visually quite similar and will be
described in detail below.
3. Site Configuration - described in
Site specific configuration for each side of the link is available at any time - under a run-
ning link or under the restricted Installation mode.
Site Configuration consists of a set of panels, which may be invoked individually in any
order, as needed.
An installed and configured link can be returned to installation mode for re-
installation and configuration from last settings or from factory settings.
Note
Default WinLink 1000 Settings
The default settings of the WinLink 1000 configuration parameters are listed in the second
column of Table 4-4
illustrative purposes.
Table 4-4: Default Settings
Parameter
Factory default band
ODU IP Address
Subnet Mask
Trap destination
RADWIN Manager log-on
passwords
Observer
Operator
Installer
Link ID
Link Name
Site 1
Site 2
Location (per site)
Name (per site)
Contact (per site)
Link Password
Rate
WinLink 1000 User Manual
Chapter
• Reversion to installation mode requires a complete break in the link
service
• Configuration mode may vary the service throughput and quality, but
without a service break
below. The third column shows the values we use in this manual for
Default Value
Product dependent
10.0.0.120
255.0.0.0
0.0.0.0
Link
Name
Site
Site
Location
Name
Person
Release 1.9.40
8.
Illustrative Value
5.780GHz
192.168.2.101 and 102
255.255.255.0
0.0.0.0
admin
admin
wireless
EBG_20561334
TPSF_BTT
A
B
A B
Here There
John Mary
wireless-bridge
Adaptive
Chapter 4
4-11