Figure 19-7 Mainw - Radwin WinLink 1000 User Manual

The procedure
12. Click Yes to accept the change. After about half a minute the changes will be reg-
istered in the ODU. On the left hand panel of the main window, you will see the new
IP configuration for the ODU.
Figure 19-7: Main Window after IP Address change
Some additional things you may want to do now:
Note
13. Click Cancel to leave the open Management dialog. You may now exit the RADWIN
Manager, or connect to another ODU. If you choose to connect to another ODU,
after about a minute, the main window of the RADWIN Manager will revert to that
shown in Figure 19-2
changes will take effect when you power it up again.
Don't forget to remove the RF terminators from a connectorized ODU after
powering it down.
Note
WinLink 1000 User Manual
• Go to Site Installation | Air Interface. You can enter a Link ID
and change the Installation Frequency and Channel Bandwidth.
• If you log on as Installer, you can change the default band
20).
above. In any event, power down the changed ODU; your
Release 1.9.40
Chapter 19
(Chapter
19-5