Figure 8-23 Telnetm - Radwin WinLink 1000 User Manual

Configuration with Telnet
Table 8-2: Telnet Commands Summary (Continued)
Command
set contact <new contact>
set ethernet <port:MNG,LAN1,LAN2>
<mode:AUTO,10H,10F,100H,100F,DISABLE>
reboot
help
Figure 8-23, below, shows the available Telnet commands using the help command.
admin@192.168.2.101-> Type "help" for help.
admin@192.168.2.101-> help
display inventory
display management
display link
display ethernet
display tdm
display ntp
display PM <interface:AIR,MNG,LAN1,LAN2,TDM1,TDM2,TDM3,TDM4>
<interval:current,day,month>
set ip <ipaddr> <subnetMask> <gateway>
set trap <index:1-10> <ipaddr> <port:1-65535>
set readpw <writePasswd> <newPasswd>
set writepw <writePasswd> <newPasswd>
set trappw <writePasswd> <newPasswd>
set buzzer <mode:0=OFF,1=ON>
set tpc <power:Value between minimal TX power, and maximal TX power>
set bridge <mode:0=Bridging OFF,1=Bridging ON>
set name <new name>
set location <new location>
set contact <new contact>
set ethernet <port:MNG,LAN1,LAN2> <mode:AUTO,10H,10F,100H,100F,DISABLE>
reboot
help
Command "help" finished OK.
Figure 8-23: Telnet Management window
WinLink 1000 User Manual
Explanation
Set the name of the site manager
Set the mode and speed of each Ethernet port
Resets both the IDU and the ODU. The user is warned that the command
will reset the ODU. A new Telnet session to the ODU may be opened
after the reset is complete. (Watch the IDU LEDs.)
Displays the available commands
Release 1.9.40
Chapter 8
8-27