Connecting User Equipment; Connecting And Aligning Odus / Antennas - Radwin WinLink 1000 User Manual

Connecting User Equipment


To prepare a link using PoE devices:
1. To connect the ODU to the PoE device, route the cable from the ODU to the PoE
device, secure the cable along its path and connect the cable to the LAN-OUT RJ-45
connector on the PoE device.
2. Connect it to AC power.
3. Repeat steps 1 to 2 for the second link.
4. If you are using a BDU, you should refer to the RADWIN Base Distribution Unit User
Manual.
Connecting User Equipment

To connect user equipment to an IDU:
1. Connect user switch/router or any other compatible device to the IDU panel RJ-45
ports designated LAN. (For an IDU-C, see item C in
2. Connect user E1/T1 traffic to the IDU panel RJ-45 ports designated TRUNKS. (For an
IDU-C, see labeled item L in
3. IDU-C only: To use the SFP Port (labeled item D in
SFP plug-in module into the port and connect the user switch/router or any other
compatible device to the SFP plug-in module.
Refer to Appendix B
Do not connect two LAN ports to the same network, or flooding may occur.
Note

To connect user equipment to a PoE device:
• Connect a user switch, router or any other compatible device to the PoE device RJ-45
port designated LAN-IN. Refer to

Connecting and Aligning ODUs / Antennas

You perform antenna alignment using the ODU's audible tone.
The method is not suitable for the following models:
Model See Reference
BRS Chapter 25
FCC/IC 5.4 / 5.3 GHz Chapter 16
To speed up the installation time, alignment of a WinLink 1000 system should be performed
by two teams simultaneously, at site A and at site B.

To align the ODUs using the alignment tone:
1. Verify that power is connected to the IDUs at both sites.
WinLink 1000 User Manual
Figure 3-13
for connector pinouts.
Appendix B
Release 1.9.40
Figure 3-13
above.)
Figure 3-13
for connector pinouts.
Chapter 3
above.)
above), insert an
3-14