Radwin WinLink 1000 User Manual page 60

Mounting the IDU-C
Table 3-1: Components of an IDU-C front panel
Key Label
G Primary 3 pin Power Connector
H Secondary 3 pin Power Connector
I Grounding Lug
J Rack mounting holes
K Detachable Rack mounting brackets
L 0, 4, 8 or 16 E1/T1 Ports
M Standby Port
The Indicator LEDs (Item A in
Figure 3-14: IDU-C Front Panel LEDs
The IDU-E Front Panel LEDS look like this and are functionally the same as the IDU-C LEDs.
Figure 3-15: IDU-E Front Panel LEDs
The purpose of the LEDs is shown in
Table 3-2: IDU-C and IDU-E/R Front Panel LEDs
Name Color
Green
Blinking Green
IDU Red
Blinking Orange
Green
ODU
Red
Green
AIR I/F Orange
Red
WinLink 1000 User Manual
Remarks
Standard 3 pins in line power connector, see
Use the lug supplied.
See Table
Hot Standby ready: HSB cable socket, see
Table 3-1 above) are shown in more detail below:
Table 3-2
Function
IDU operational
During power-up only
Failure
During power-up; continues if ODU fails to load IDU firmware.
Also, when using an IDU-C to replace a PoE device in which case all other LEDs off.
ODU-to-IDU communication link is operating
ODU-to-IDU communication link is disrupted
Wireless link is synchronized
During installation mode; also signals software mismatch on some identical ODUs
Wireless link lost synchronization
Release 1.9.40
B-5.
below:
Chapter 3
Table B-8.
Table B-6.
3-11