Figure 8-22 Telnet Session Log On; Table 8-2 Telnet Commands - Radwin WinLink 1000 User Manual

Configuration with Telnet
Figure 8-22: Telnet session log on
A Read-Only Community string allows display only whereas a Read-Write Community string
allows display and set commands.
Supported Telnet commands are shown in
model-specific. For example, TDM commands will not apply to Ethernet only and PoE based
links.
Table 8-2: Telnet Commands Summary
Command
display inventory
display management
display link
display ethernet
display tdm
display ntp
display PM <interface:AIR,LAN1,LAN2,TDM1,
TDM2,...,TDM4> <interval:current,day,month>
set ip <ipaddr> <subnetMask> <gateway>
set trap <index:1-10> <ipaddr> <port:0-
65535>
set readpw <oldpasswd> <passwd>
set writepw <oldpasswd> <passwd>
set trappw <oldpasswd> <passwd>
set buzzer <mode:0=OFF,1 =ON>
set tpc<power:Value between minimal Tx power,
and maximal Tx power>
set bridge <mode:0=Bridging OFF,1= Bridging
ON >
set name <new name>
set location <new location>
WinLink 1000 User Manual
Table 8-2. Note that some of the commands are
Explanation
Displays ODU product name, Name, Location, hardware and software
revisions, uptime, MAC address, IDU product name, IDU software and
hardware revisions
Displays IP, Subnet, Gateway, Traps table
Displays State, Link ID, Channel BW, RSS, TSL, Frequency/ACS, DFS,
Rate/ARA, Distance
Displays Bridge Mode, Aging time, Port table (State, Status and action)
Displays Clock Mode, Master Clock Mode, Current Clock, Quality, TDM
table (Line status, Error Blocks)
Displays Time, Server and Offset
Shows the performance monitor tables for each interface according to
user defined monitoring intervals
Set the ODU IP address, subnet mask and gateway. The user must reset
the ODU after the command completion
Set a specific trap from the traps table (e.g. set trap 3 192.168.2.101
162)
Set the read access password (Read Community)
Set the read-write access password (Read-Write Community)
Set the trap Community string
Toggle the buzzer mode (0 – off, 1 – on)
Set the ODU Tx Power. If a wrong value is entered, both min and max
values shall be displayed in the error reply
Set the ODU bridge mode (0 – off, 1 – on)
Set the name of the link
Set the name of the location
Release 1.9.40
Chapter 8
8-26