Radwin Manager Traps - Radwin WinLink 1000 User Manual

RADWIN Manager Traps

Table D-3: MIB Traps (Sheet 5 of 5)
Name
compatibleIdus
desiredRatioCanNotBeAppliedClear
cbwMatch
switchCbwAndChannel
ringRplStateIdle
ringEthServiceStatus
ringFirstRpmReceived
ringEthernetSrviceUnblockedTO
gpsSynchronized
RADWIN Manager Traps
The RADWIN Manager application issues traps to indicate various events. These traps are
shown in the RADWIN Managerr Events Log.
A list of Trap Messages as displayed by the RADWIN Manager is shown in
WinLink 1000 User Manual
ID Severity Description
228 normal Indicates that the ODU has identified compatible Idus on both sides of the
link.
229 normal Indicates Current UL/DL Ratio Is Equal To Desired Ratio.
230 normal Indicates that a Channel Bandwidth match was detected. Contains a
single parameter which is its description: 1 - Channel Bandwidth value
in MHz.
231 normal Indicates that the system is switching Channel Bandwidth and channel
frequency. Contains two parameters: 1 - Switching to Channel
Bandwith %n0 MHz and to channel %n1 GHz.
232 normal RPL state changed to Idle.
233 normal Indicates Ethernet service's state - blocked \ unblocked. Contains a
single parameter: 1 - Description: Ethernet's state (blocked \ unblocked)
234 normal Ring application: in non-RPL link indicates first from a specific RPL was
received. Contains a single parameter: 1 - Description: RPM's VLAN ID
235 normal Ring application: in non-RPL link Ethernet service is unblocked due to
RPM timeout.
236 normal Indicates that the GPS is synchronized with satellites.
Release 1.9.40
Appendix D
Table 9-5.
D-28