Figure 14-7 U; Figure 14-8 P - Radwin WinLink 1000 User Manual

VLAN Tagging for Ethernet Service: Configuration
Figure 14-5: VLAN: Ingress mode - setting VLAN ID and Priority
Throughout this chapter, all VLAN IDs must be between 1 and 4094,
inclusive. All VLAN priorities must be between 0 and 6, inclusive. The values
entered are range-checked. If for example, you enter a VLAN ID of 4095,
Note
then 4094 will be reflected back.
The choices for Egress Mode are -
Figure 14-6: VLAN: Egress modes
The five non-transparent choices correspond respectively to the five rows of
the order, row 1, 2, 4, 5, 3.
The first two choices, Transparent and Untag all require no further action.
Untag selected VIDs causes the eight VLAN ID fields to become available:
Figure 14-7: Untagging selected VIDs
You may nominate up to eight VIDs for untagging; beyond simple range checking, there is no
other validation.
Both Provider tagging and Provider tagging without filter enable the Provider
parameters fields:
Figure 14-8: Provider parameters
WinLink 1000 User Manual Release 1.9.40
Chapter 14
Table 14-2 in
14-8