Radwin WinLink 1000 User Manual page 29

Key Features of WinLink 1000
RADWIN's WinLink 1000 products can be installed in a unique multi point-to-point
architecture. Multiple units are deployed in one hub site location, from where they
provide a dedicated, high-capacity connection to each remote site.
This unique concept builds on RADWIN Hub Site Synchronization (HSS) feature, which
synchronizes the transmission of collocated WinLink 1000 and RADWIN 2000 units,
thus virtually reducing mutual interference commonly experienced with collocated
TDD radios.
»
HSS Interoperability between RADWIN 2000 and WinLink 1000
Site Synchronization is supported with any mix of RADWIN 2000 and WinLink 1000
links. RADWIN 2000 can be used to backhaul WinLink 1000 collocated links without
mutual interference
»
Monitored Hot Standby (1+1):
The RADWIN Monitored Hot Standby (MHS) protects up to sixteen E1/T1 services with
RADWIN 2000 and up to four E1/T1 services with WinLink 1000. It is designed to
provide high reliability high-capacity Point-to-Point Links. The RADWIN MHS is -
• Designed to provide redundancy and high reliability for carrier class operators
• Optimized for high capacity links operating in license-free bands
• A comprehensive solution providing protection against both equipment failure
and loss of air interface, by simple connectivity between a primary link and a sec-
ondary link
Able to use a different band for maximum protection to the air interface
The main features of the RADWIN MHS are –
• Cut-over from the primary to the secondary link completely automatic
• Cut-over time no more than 50 ms
• Automatic restore to primary link as soon as it becomes available
• WinLink 1000 can backup a RADWIN 2000 link
A major benefit of RADWIN MHS is that is can underpin an affordable Service Level
Agreement structure by protecting part of the RADWIN 2000 trunks with WinLink
1000.
MHS supports TDM services; Ethernet services are carried by both links independently.
»
Enhanced Air Interface Security
WinLink 1000's AES 128-bit key encryption provides enhanced air interface security.
»
Advanced Management and Performance Monitoring
The WinLink 1000 Manager software has full local and remote management capabili-
ties. The user-friendly SNMP based management tool provides full end to end configu-
ration, event log, and performance monitoring capabilities.
Multiple WinLink 1000 links can be managed by RADWIN Network Management Sys-
tem (RNMS).
»
SFP support in the IDU-C
Standard SFP modules are used, enabling any type of Ethernet physical connectivity
including various fiber connections. E3/T3 or E1/T1 over Ethernet SFPs can be used as
well.
»
Separate management and traffic VLAN support
WinLink 1000 User Manual Release 1.9.40
Chapter 1
1-5