Purpose of this Chapter
Purpose of this Chapter
This chapter is an installation and maintenance guide for RADWIN MHS. It applies to all RAD-
WIN radio products able to support the Monitored Hot Standby operational mode.
Who Should Read this
This chapter is intended for persons responsible for the installation and maintenance of RAD-
WIN MHS. To use it you need to know how to -
•
Install a WinLink 1000 radio link
•
Install a RADWIN 2000 radio link
•
Use the RADWIN Manager software
RADWIN MHS Kit Contents
•
One Y-Connection Patch Panel
•
One MHS cable
Figure 12-2: RADWIN Y-Connection Patch Panel
Installing a RADWIN MHS
The following procedure is substantially generic to all RADWIN radio
products. Differences between WinLink 1000 and RADWIN 2000 class
products will be stated explicitly. What you see on your running RADWIN
Manager may differ in some details from the screen captures used to
Note
illustrate this chapter.
Figure 12-1
above is a schematic of a RADWIN MHS.
the IDUs to the Patch Panel.
WinLink 1000 User Manual
Figure 12-3
Release 1.9.40
Chapter 12
shows how to connect
12-3