Installation
The optimum transmission rate for the selected services is evaluated.
Following a short delay for processing, Back and Next are enabled.
4. Click Next to continue.
The transmission rates used by WinLink 1000 are shown in
above.
Note
Step 6, TDM Clock Configuration
The following dialog is displayed:
Figure 5-19: TDM Parameters Configuration (1)
To configure TDM clock parameters:
1. For any individual port, click it. For the same parameters for all ports, click
the Select Maximum tag.
Note
2. Click Configure. The following drop down list is displayed:
WinLink 1000 User Manual
•
Select Maximum will select the maximum number of services that
were configured for the air interface for configuration
•
Deselect All unconditionally deselects all of the services for configu-
ration
•
Without selecting anything, right-clicking any port will cause the
appearance of the drop down list of
Release 1.9.40
Table 5-4
Figure 5-30
below
Chapter 5
5-16