Setting The Date And Time - Radwin WinLink 1000 User Manual

Setting the Date and Time

The link to the remote unit is now locked. If you repeat steps 1 and 2 above, the
Security screen will look like this:
The Link Lock check-box is now unavailable.
5. If required, repeat the procedure for Site B.
To revert the Link Lock status to unlocked, power down each ODU
in turn. Use the above procedure to uncheck the Link Lock status
Note
box for the live ODU.
A simple ODU reset at either end will restore the link to its previous
locked or unlocked state.
Setting the Date and Time
The ODU maintains a date and time. The date and time should be synchronized with any Net-
work Time Protocol (NTP) version 3 compatible server.
During power-up the ODU attempts to configure the initial date and time using an NTP Server.
If the server IP address is not configured or is not reachable, a default time is set.
When configuring the NTP Server IP address, you should also configure the offset from the
Universal Coordinated Time (UTC). If there is no server available, you can either set the date
and time, or you can set it to use the date and time from the managing computer. Note that
WinLink 1000 User Manual Release 1.9.40
Chapter 8
8-13