Getting Started With The Radwin Manager - Radwin WinLink 1000 User Manual

Getting Started with the RADWIN Manager

?
2. Choose Install RADWIN Manager and follow the on-screen instructions of the instal-
lation wizard to complete the setup of the RADWIN Manager application.
If the installation program fails to start, browse to your CD/DVD drive, chose the
setup.exe program and run it.
Getting Started with the RADWIN Manager
If your links are within easy reach, you can configure them using the procedure described
below. If however, your links are to be geographically scattered, it may be convenient to pre-
load each ODU with its network address prior to physical installation. The procedure is quite
straight forward, and set out in
Each ODU requires a static IP address, since part of the link definition is the
IP address pair of both ODUs. Network Managers should ensure that these
addresses are outside of the automatic allocation ranges used by their
Note
network DHCP server.

To start the RADWIN Manager:
1. Connect the managing computer to one of the two LAN ports as shown in
1 below:
WinLink 1000 User Manual
Chapter 19.
Release 1.9.40
Chapter 4
Figure 4-
4-2