Radwin WinLink 1000 User Manual page 121

Configuring VLAN Settings
The VLAN described here is a for management purposes and is intended to
govern access by a managing computer. It is not to be confused with
Ethernet service traffic VLAN described on
Note

To enable VLAN management:
1. Click Configuration from the main menu.
2. Choose a site to configure. If you are configuring both sites, choose site B first to
avoid locking yourself out.
3. Choose Management.
4. Open the VLAN tab.
5. Check the Enabled box.
6. Enter a VLAN ID. Its value should be between 1 and 4094.
After entering the VLAN ID, only packets with the specified VLAN ID are processed
for management purposes by the ODU. This includes all the protocols supported by
the ODU (ICMP, SNMP, TELNET and NTP). The VLAN priority is used for the traffic
sent from the ODU to the managing computer. Using VLAN for management traffic
affects all types of management connections (local, network and over the air).
7. Enter a Priority number between 0 and 7.
8. Change the VLAN ID and Priority of the managing computer NIC to be the same as
those of steps 6 and 7 respectively.
Changing this parameter causes the RADWIN Manager to immediately
disconnect. To avoid inconvenience, you should verify the change by
setting the VLAN only to one ODU, and only after verifying proper
Caution
management operation, change the other ODU VLAN setting.
9. Click Apply or OK.
WinLink 1000 User Manual Release 1.9.40
page 8-17 and Chapter
Chapter 8
14.
8-7