Connecting Power To The Idu; Connecting The Odu To The Idu; Installing A Link Using Poe Devices - Radwin WinLink 1000 User Manual

Connecting power to the IDU

3. Ground the IDU to the rack using grounding lug I. The IDU should be left perma-
nently grounded.
Instead of using the rack mounting brackets, the IDU may be rail mounted
using the four screw holes on each of its sides.
Note
Connecting power to the IDU
The IDU-C has redundant power connection circuits (items G and H in
An enlarged schematic of the power connectors is shown in below:
Figure 3-16: IDU-C Power connectors
The connectors are 3 pin in line female, with polarities (left to right) minus, ground, plus. To
avoid damage to the IDU, always use an AC/DC adapter supplied by RADWIN.
Ensure that the IDUs at both sites are powered up.
The IDU-E has a single three pin power connector, the same as used on the IDU-C.
The IDU-R models have a two pin power connector and an AC/DC adapter supplied by RAD-
WIN.

Connecting the ODU to the IDU

The ODU-IDU cable conducts all the user traffic between the IDU and the ODU, and also pro-
vides power to the ODU. The maximum length of the ODU-IDU cable is 100m (328ft) in
accordance with 10/100BaseT standards.
The ODU-IDU cable is supplied pre-assembled with RJ-45 connectors, at the length specified
when ordering, or as a cable drum with spare connectors. If the ODU-IDU cable was not
ordered, use an outdoor class, CAT-5e 24AWG shielded cable. See
Specifications.
To connect the ODU to the IDU, route the cable from the ODU to the IDU, secure the cable
along its path and connect the cable to the ODU RJ-45 connector on the IDU (see item B in
Figure 3-13 above).

Installing a Link using PoE Devices

The PoE device is a very simple unit having a power input connector and two Ethernet ports.
It is AC powered, and has a power LED.
WinLink 1000 User Manual Release 1.9.40
Chapter 3
Figure 3-13 above).
Appendix B for Wiring
3-13