Chapter 5 Configuring The Link; Link Configuration: Getting Started; The Main Window Of The Radwin Manager - Radwin 2000 User Manual

This chapter describes the link configuration procedure, which is performed
after the installation of both sides of the RADWIN 2000 link, as set out in
chapters
Link configuration uses a Link Configuration wizard to redefine the configu-
ration parameters and fine-tune an operational link. Both sides of the link
are configured simultaneously.
Link configuration allows you to configure link parameters, which do not
lead to sync loss or require a reset. Some may change service performance,
in respect of which, warnings are displayed.
For ease of use, the Link Configuration wizard follows the same pattern as
Link Installation. You should therefore be familiar with the content of chap-
ter 4.
The following parameters are configured using the Link Configuration Wiz-
ard:

Link Configuration: Getting Started

The Main Window of the RADWIN Manager

Ensure that the RADWIN Manager is running.
The main window should look similar to that in figure 5-1:
RADWIN 2000 User Manual
Configuring the Link
3 and 4.
• System parameters
• Channel settings
• Transmission power and antenna settings
• Service parameters
Release 2.2
Chapter 5
5-1