Table 10-6 External Pulse - Radwin WinLink 1000 User Manual

Link Configuration and HSS
• Hub Sync Client - Continue Transmission (HSC-CT)
Continue Transmission is intended to work if there is no HSM pulse. If a
wrong HSM pulse is detected, a WinLink 1000 will resync, adapting to the
HSM RFP and continue whereas RADWIN 2000 may stop.
Note
• Independent Unit
• Synchronization:
• N/A- for Master or Independent Units
• Synchronized - for Hub Site Clients
• Not Synchronized - for Hub Site Clients
• External Pulses:
Table 10-6: External Pulse Status
HSS Sync Status
Generating
Detected
Not detected
Generating and detected
Generating and
Improperly Detected
Not detected
Improperly detected

To configure the Operational States of the Hub Site unit
1. Click the Enabled check box
2. Click the Configure button
The Hub Site Configuration dialog box with the current status of the ODUs is dis-
played.
3. Select the type of unit configuration from the drop-down list.
4. Select the appropriate RFP radio button. Some RFP options may be disabled depend-
ing on the bandwidth previously selected.
Take care to avoid incorrect configuration of bandwidth, RFP or to set
multiple Hub Sync Masters, as system interference can occur. RADWIN
Manager provides error messages and tool tips if the system is configured
Note
with mismatches.
WinLink 1000 User Manual
Meaning
ODU is HSM and generates the
sync pulse
ODU is HSC and detects the
sync pulse
ODU is independent
HSM, but other HSM present
RADWIN 2000 ODU is HSM,
but but detects a WinLink 1000
HSM signal that is not RFP E
HSC but no HSM present
HSC but HSM pulse doesn't fit
the HSC as configured. Occurs
only for RADWIN 2000, which
stops transmitting.
Release 1.9.40
Color code
Green
Orange
Red
Chapter 10
10-13