General Specifications - Mitsubishi Electric AJ65BT-D75P2-S3 User Manual

3 SPECIFICATIONS AND FUNCTIONS

3.1 General specifications

Item
Operating ambient
temperature
Storage ambient temperature
Operating ambient humidity
Storage ambient humidity
Vibration resistance
Shock resistance
Operating atmosphere
3
Operating altitude*
Installation location
1
Overvoltage category *
2
Pollution degree*
1 This indicates the section of the power supply to which the equipment is assumed to be
*
connected between the public electrical power distribution network and the machinery within
premises.
Category II applies to equipment for which electrical power is supplied from fixed facilities.
The surge voltage withstand level for up to the rated voltage of 300V is 2500V.
2 This index indicates the degree to which conductive material is generated in terms of the
*
environment in which the equipment is used.
Pollution level 2 is when only non-conductive pollution occurs. A temporary conductivity
caused by condensing must be expected occasionally.
3 Do not use or store the programmable controller under pressure higher than the atmospheric
*
pressure of altitude 0m. Doing so may cause malfunction. When using the programmable
controller under pressure, please consult your local Mitsubishi representative.
4 This applies only when all waterproof connectors are being used or when waterproof caps are
*
attached to unused waterproof connectors or pipes. (Only the AJ65SBTW -16
5 The module can be used in an environment other than inside a control panel if the conditions
*
such as the operating ambient temperature and humidity are satisfied.
*6 For the waterproof type remote I/O module (AJ65SBTW -16
temperature and storage ambient temperature will be as follows.
The general specifications of the D75P2 are given below.
(The waterproof type remote I/O module is compliant with IP67. *
Under
Compliant
intermittent
with JIS B
vibration
3502 and IEC
Under
61131-2
continuous
vibration
Specifications
0 to 55 ° C*
-20 to 75 ° C*
10 to 90% RH, non-condensing
10 to 90% RH, non-condensing
Frequency Acceleration
5 to 8.4Hz
8.4 to 150Hz 9.8m/s
5 to 8.4Hz
8.4 to 150Hz 4.9m/s
Compliant with JIS B 3502 and IEC 61131-2
2
(147 m/s , 3 times each in 3 directions X, Y, Z)
No corrosive gases
0 to 2000m
Inside a control panel*
or less
2 or less
3 - 2
MELSEC-A
6
6
Amplitude
– 3.5mm
10 times each in
X, Y, Z directions
2
–
– 1.75mm
2
–
5
only), the operating ambient
4
Sweep count
–
has pipes.)