Advertisement
4
INSTALLATION, WIRING AND MAINTENANCE OF THE PRODUCT
4.5.3 Connecting the connector
The D75P2 is connected to the drive unit or peripheral device with the connector. Use
the following procedure to connect.
(1)
Connecting
(a)
Confirm if all phases of the externally supplied power for the
system are switched off or not.
* If not, switch off all phases.
(b)
Confirm the module connector connection state and
connector shape, and match the engagement orientation.
(c)
Press the connector straight into the module until a "click" is
heard.
[Work checks]
After cable connection, check the work as in the following list.
Check the connector for looseness.
(2)
Removing
(a)
Confirm if all phases of the externally supplied power for the
system are switched off or not.
* If not, switch off all phases.
(b)
Press in the latches on both sides of the connector, and pull
the connector straight off.
4 - 24
MELSEC-A
Advertisement
Chapters
Troubleshooting
