Mitsubishi Electric AJ65BT-D75P2-S3 User Manual page 549

13 COMMON FUNCTIONS
(1) "Module status" display details
"Module status" displays the operation status of the D75P2.
17-segment LED Axis indicator LED
RUN Operating axis flickers.
TEST All axes turn on.
IDL Off
ERR LED of axis in error flickers. During error occurrence
(2) Axis status" display details
"Axis status" displays the operation statuses of the axes.
The status of one axis is switched to that of the other every 0.5 seconds.
17-segment LED Axis indicator LED
IDLE
STOP
JOG
MANP
OPR
POSI
The lit LED changes every
VELO
0.5 seconds.
V- P
V -P
BUSY
E***
Error number display
When the axis has an error, the error number that has occurred in that axis
is displayed 0.5 seconds, and the status of the next axis is then displayed.
(3) "I/O information n" display details
"I/O information n" displays the status of each signal.
The "Axis indicator LED" turns on.
17-segment LED Axis indicator LED
SVON
Z-ON
ULMT
Lit when the displayed
signal is ON.
LLMT
V-P
DOG
(4) Other display details
The following error message is displayed in the 17-segment LED independently
of the mode.
17-segment LED Axis indicator LED
FALT
During axis operation
During test mode
During standby
During standby
During stop
During JOG operation
During manual pulse generator operation
During zero point return
During position control
During speed control
During speed control of speed/position
changeover control
During position control of speed/position
changeover control
During condition waiting, etc.
At error occurrence
Drive unit READY signal
Zero point signal
Upper limit signal
Lower limit signal
Speed/position changeover signal
Near-point dog signal
This error message is displayed when the flash
ROM value becomes illegal.
Execute initialization.
The cause of the error is a hardware fault if the
error message is displayed after execution of
initialization.
13 - 9
MELSEC-A
Details
Details
Details
Details