Mitsubishi Electric AJ65BT-D75P2-S3 User Manual page 206

5 DATA USED FOR POSITIONING CONTROL
Da.13 Parameter
Set the value as required for " Da.12 Special start command".
Da.12 Special start command
Block start (Normal start)
Condition start
Wait start
Simultaneous start
Stop
Repeated start (FOR loop)
Repeated start (FOR condition)
Setting value
– Not used. (There is no need to set.)
Set the condition data No. (No. of
"condition data" set to perform
condition judgement)
1 to 10
(For details of the condition data, refer
to Section 5.5.)
– Not used. (There is no need to set.)
0 to 255 Set the No. of repetitions.
Set the condition data No. (No. of
"condition data" set to perform
1 to 10 condition judgement)
(For details of the condition data, refer
to Section 5.5.)
5 - 74
MELSEC-A
Setting details