Mitsubishi Electric AJ65BT-D75P2-S3 User Manual page 275

6 SEQUENCE PROGRAM USED FOR POSITIONING CONTROL
No.7
No.8
No.9
No.10
No.11
Continued from previous page
Positioning start No. setting program
Positioning start signal input program
Reset, M code OFF program
JOG operation program
Manual pulse generator
operation program
Continued on next page
Start details setting program
Refer to section 6.6.2
Start program
Refer to section 6.6.3
Program to reset the start
signal and turn the M code
ON signal OFF
JOG operation program
Refer to section 11.2
Manual pulse generator
operation program
Refer to section 11.3
6 - 31
MELSEC-A
* Program required to carry out
• "Zero point return control"
• "Main positioning control"
• "Advanced positioning control"
* Program required to carry out
"manual control"