Removing The Top Cover And Foam - Agilent Technologies 1100 Series Reference Manual

Removing the Top Cover and Foam

When required
Tools required
Parts required
Preparations for this procedure:
•
Turn off the detector.
•
Disconnect the power cable.
•
Disconnect capillaries.
•
Remove detector from stack and place it on the
working bench.
2
interface board. Place the board on the ESD kit.
1100 Series DAD and MWD Reference Manual
For all repairs inside the detector
Screwdriver POZI 1 PT3
Screwdriver
Depends on the work inside and the following
procedures
Install the ESD strap. If installed, unscrew and
135
Repairing the Detector
remove the
4