Configuration | Routing - Comtech EF Data CDM-760 Installation And Operation Manual

Ethernet Interface Operation
CDM-760 Advanced High-Speed Trunking Modem
7.4.4.3.4 Configuration | Routing Pages
1) The Routes, DHCP, and DNS pages are accessible only to Admin users when the
optional High-Speed Packet Processor card is installed and enabled. See Sect.
7.4.3.1 for information about using these conditional access pages.
2) At present, only Point-to-Point Routing is allowed on the CDM-760. Point-to-
Multipoint Routing will be enabled on future releases.
Click the Routing primary page tab, and the select the Routes, DHCP, or DNS tab to continue.
7.4.4.3.4.1 Configuration | Routing | Routes
Appendix F. OPTIONAL HIGH-SPEED PACKET PROCESSOR Sect. F.3.1.1.1
Static Route Configuration
Use this page to enter static routes into the Packet Processor to route IP traffic over the satellite
or to another device on the local LAN.
Figure 7-15. Configuration | Routing | Routes Page
7–29
Revision 4
MN-CDM760