Table of Contents
Advertisement
Ethernet Interface Operation
CDM-760 Advanced High-Speed Trunking Modem
7.4.4.3.10
Configuration: CID (Carrier ID)
Configure your settings as needed. Click [Submit] to save.
Meta-Carrier Info
•
The read-only
•
Set the modem's physical location in Latitude in the form DDMM.mmC, where:
o DD = degrees (00 through 90)
o MM = whole minutes (00 through 60)
o mm = fractional minutes (0 through 99 (tenths or hundredths))
o C = compass cardinal point (N = North, S = South)
•
Set the modem's physical location in Longitude in the form DDDMM.mmC, where:
o DDD = degrees (000 through 180)
o MM = whole minutes (00 through 60)
o mm = fractional minutes (0 through 99 (tenths or hundredths))
o C = compass cardinal point (E = East, W = West)
•
Enter a CID Telephone Number to provide a valid emergency contact number to call to
resolve operational issues – e.g., in case the modulator's Tx output is causing interference
on the satellite. Providing this phone number allows a satellite operator to quickly call the
person(s) responsible for correcting any issues.
•
Create a Custom Message to provide additional information that may be useful in resolving
operational issues, e.g., to quickly resolve interference.
•
Use the Carrier ID State drop-down list to select operation as On or Off. This setting enables
the transmission of CID information by the modem. The default is On.
Click [Submit] to save your settings.
Figure 7-26. Configuration | CID Page
MAC Address for t
he M&C card on the CDM-760 is displayed here.
7–47
Revision 4
MN-CDM760
Advertisement
Table of Contents
