Reboot The Modem - Comtech EF Data CDM-760 Installation And Operation Manual

Updating Firmware
CDM-760 Advanced High-Speed Trunking Modem
4.4.5

Reboot the Modem

Reboot the CDM-760 using one of the following methods:
• For a hard reboot – Use the rear panel ON/OFF switch (or otherwise disconnect the modem
power source), and then reconnect the modem power.
• For a soft reboot – Click [Reboot Modem] in the Firmware Image Config section of the HTTP
Interface Admin | Upgrade page.
Note that, if booting into a new image and the Top Card Application has been changed, an
additional step occurs as the CDM-760 downloads to a different flash memory. This additional
upload takes approximately two minutes.
Once the modem reboots, the Web browser prompts you to re-enter the User Name and
Password in order to resume use of the HTTP Interface.
The CDM-760 is now operating with its latest firmware. The firmware update process is now
complete.
4–14
Revision 4
MN-CDM760