Table of Contents
Advertisement
Serial Interface Operation
CDM-760 Advanced High-Speed Trunking Modem
Controller-to-Target
Instruction Code and
Qualifier
Parameter Type
Command
Query
CnC Fractional
N/A
FCC?
Time Remaining
Time remaining in
N/A
FCF?
365 day period
N/A
Demo Time
DMT?
remaining
Arguments for
Description of Arguments
Command or
(Note that all arguments are ASCII numeric codes from 48 to 57)
Query
11 bytes
Query only.
Returns the fractional CnC time remaining in the current 365 day period in the form DD:HH:MM:SS, where:
DD=The number of days
HH=The number of hours
MM=The number of minutes
SS=The number of seconds
NOTE: This timer is only active when fractional CnC is purchased and CnC is enabled and running. When the timer hits
zero, CnC will be disabled until the current 365 day period expires. When the current 365 day period expires, the
fractional timer will automatically reset to 90 days.
11 bytes
Query only.
Returns the time remaining in the current 365 day period, in the form DD:HH:MM:SS, where:
DD=The number of days
HH=The number of hours
MM=The number of minutes
SS=The number seconds
NOTE: When the timer hits zero, it will automatically reset to and begin counting down again.
11 bytes
Query only.
Returns the Demo time remaining in the form DD:HH:MM:SS, where:
DD=The number of days
HH=The number of hours
MM=The number of minutes
SS=The number seconds
IMPORTANT NOTE! The Demo Mode timer cannot be reset. This timer is active only when Demo Mode is enabled.
When the timer hits zero, Demo Mode is permanently disabled.
8–40
Revision 3
MN-CDM760
Target-to-Controller
(see Description of Arguments)
Response to
Response to
Command
Query
N/A
FCC=DD:HH:M
M:SS
N/A
FCF=DD:HH:M
M:SS
N/A
DMT=DD:HH:M
M:SS
Advertisement
Table of Contents
