Table of Contents
Advertisement
Appendix A
CDM-760 Advanced High-Speed Trunking Modem
In order for the Image that was just updated to be 'active' the next time you reboot the
modem, you must select that firmware image to be the Current Active Image. Use the ▲▼
arrow keys to select 1 or 2. (In this example, Image #1 was updated and is therefore the
required choice.)
Alternately, on the CDM-760 HTTP Interface Configuration | Utilities page, use the Next
Reboot Image drop-down list in the Firmware Image Config section to select Image1 or
Image2, and then click [Submit]:
Once you press ENTER on the front panel or click [Submit] from the CDM-760 HTTP
Interface, the modem verifies the checksums of all the files that are being updated:
This process takes several minutes. Do not turn off the modem during this time. When the
process is complete, this message displays:
9. Reboot the CDM-760 using one of these methods:
•
For a hard reboot – Use the rear panel ON/OFF switch (or otherwise disconnect the
modem power source), and then reconnect the modem power.
•
For a soft reboot – From the Firmware Image Config section of the CDM-760 HTTP
Interface Configuration | Utilities page, click [Reboot Modem]:
Note that, if booting into a new image and the Top Card Application has been changed, an
additional step occurs as the CDM-760 downloads to a different flash memory. This
additional upload takes approximately two minutes. Once the modem reboots, you will be
prompted to re-enter the User Name and Password in order to resume use of the CDM-760
HTTP Interface.
10. Use one of these methods to verify that the PC-to-Modem FTP file transfer was successful:
•
From the CDM-760 Front Panel – Confirm that, upon reboot, the modem Firmware
Version that displays on the CDM-760 Front Panel VFD top-level screen matches the
firmware version just loaded. You may also review the SELECT: Utility → Firmware →
Info → Image#1 and Image#2 screens for detailed firmware information.
From the CDM-760 HTTP Interface – Review the firmware version on the Home page, or
•
the Image 1 and Image 2 folder contents on the Status | Firmware page:
Calculating checksums on selected Image.
Please wait
Selected Image has been written.
Reboot Modem or <ENTER> to Continue.
A–11
Revision 4
MN-CDM760
Advertisement
Table of Contents
