Load Parameter Set From The Controller - Lenze 9300 System Manual

Show/Hide Bookmarks
5.9.2
L

Load parameter set from the controller

The operating menu (Fig. 5-17) enables the parameter set to be loaded
•
from the controller to the PC by "Read current parameter set from the controller (F7)"
– C0002 offers the following options in the menu "Parameter set management":
1. Loading of the default setting (C0002=0)
2. Loading of customer-specific parameter set (C0002=1)
Tip!
The RDY message is not displayed while the parameter set is loaded since the controller cannot be
operated then.
Commissioning
EDSVS9332P-C EN 3.0
5-23