Reset Of Fault Messages - Lenze 9300 System Manual

Show/Hide Bookmarks
Troubleshooting and fault elimination

Reset of fault messages

8.4 Reset of fault messages
Reaction to failure
•
TRIP/ FAIL-QSP
After fault elimination, an acknowledgement is required to restart the drive.
•
Acknowledge TRIP / FAIL-QSP as follows:
– Global Drive Control: Click the "TRIP reset" button in the "Diagnostics 9300"
dialog box.
– Keypad XT:
Press STOP key. Then press RUN to enable the controller again.
– Fieldbus module: Set C0043 = 0
– Control word C0135
– Terminal X5/E5 (default setting) or "DCTRL-TRIP-RESET"
– Control word AIF
– Control word system bus (CAN)
•
Message After fault elimination, the message will be reset automatically.
•
Warning
After fault elimination, the warning will be reset automatically.
8-10
EDSVS9332P-E EN 3.0
Re-commissioning measures
8-4, ("Working with the history buffer")
Danger notes
If a TRIP source is still active, TRIP cannot be reset.
The drive restarts automatically if the message is
removed.
L