Loadable Compile Cycles (Sw 2.2 And Higher) - Siemens SINUMERIK 840Di Manual

06.03
10.7

Loadable compile cycles (SW 2.2 and higher)

Brief description
Siemens
compile cycles
User
compile cycles
 Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
10.7 Loadable compile cycles (SW 2.2 and higher)
Compile cycles are functional expansions of the NCK system software that can
be created by the operator and/or by Siemens and then imported in the control
later.
As part of the open NCK system architecture, compile cycles have comprehen-
sive access to data and functions of the NCK system level via defined software
interfaces. Therefore, you can use compile cycles to expand the functionality of
the NCK as much as you require or redefine it as far as allowed by the inter-
faces.
Until now, integrating a compile cycle in the control required an additional gener-
ation process to bind the compile cycle to the NCK system software to achieve
a complete system.
With SW 2.2 and higher, the compile cycles are no longer integrated in the NCK
by means of an additional generation process; instead they can be loaded in
the control at any time.
The following technological functions are available from Siemens as loadable
compile cycles:
– 1D/3D clearance control in position controller cycle
Order No.: 6FC5 251-0AC05-0AA0
References: /FB3/ Description of Functions Special Functions
Section clearance control (TE1)
– Continue Machining at the Contour (Retrace Support)
Order No.: 6FC5 251-0AE72-0AA0
References: /FB3/ Description of Functions Special Functions
Section Continue Machining-Retrace Support (TE7)
– Fast Laser Switching Signal
Order No.: 6FC5 251-0AE74-0AA0
References: /FB3/ Description of Functions Special Functions
Section Cycle-Independent Path-Synchronous Switching
Signal Output TE8
When you order one of the listed technological functions, you are given the cor-
responding software license number. To obtain the compile cycle itself as a
loadable file (extension .ELF for executable and linking format), please contact
your local Siemens sales representative.
Note
Compile cycles created by Siemens are options that require explicit activation
and licensing.
References: Ordering information Catalog NC 60.2002
To create your own compile cycles, in addition to the necessary NCK-specific
development environment, you need the SINUMERIK Open Architecture com-
ponent "OA package NCK".
Note
To use the SINUMERIK Open Architecture component "OA package NCK", you
need to conclude an OEM contract.
10 NC Start-Up with HMI Advanced
10-389