10 NC Start-Up with HMI Advanced
10.7 Loadable compile cycles (SW 2.2 and higher)
Data descriptions (MD)
60900 + i
with i = 0. 1. 2nd 3 ...
Default settings: 0
Changes valid after RESET
Data type: UINT16
You can activate the entire technological function in the individual NC channels
or individual subfunctions via the above mentioned general NCK machine date.
For a description of the machine data, please see Subsection 10.7.4, page
The individual technological functions are described in:
/FB3/ Description of Functions Special Functions
Sections TE1 to TE8
The compile cycles loaded in the FSS NCK are displayed together with the re-
spective version of HMI Advanced (option) in the following menu:
Operating area switchover > Service > Version > Compile cycles
with: XXXX = function identifier, n = 0 or 1
n = 0: Activation of the technological function in the NC channels
n = 1: Additional functions within the technological function
min. input limit: 0
Protection level: 2 / 7
Activation of the technological function in the NC channels
The technological function is activated in the NC channels via the MD with the index n = 0.
Bit 0 = 1: Technological function activated in NC channel 1
Bit n = 1: Technological function activated in NC channel n+1
For more details about which NC channels a technological function can be activated,
please refer to the manuals below.
Additional functions within the technological function:
Additional functions within the individual technological function can be activated via the MD
with the index n = 1. See References below.
References: /FB3/ Description of Functions Special Functions TE1 – TE8.
max. input limit: FFFF
valid from SW: 2.2
Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition